EarthQuake CRT series Instrukcja Operatora Pobierz pdf (Strona 7)

7Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

Operator’s Manual

6015 Series CRT Rototiller

handlebar extensions

ATTACH HANDLEBAR 6015BCE, EUROPE

1. Locate handlebar extensions. (SEE FIGURE 2)

2. Place handlebar extensions on outside of lower handlebar

mount. Line up the handlebar extension pieces with the lower

handlebar mount as shown in the decal located on the lower

handlebar mount next to the mounting location. (SEE PAGE 21)

3. Insert one 3/8-16 x 1 3/4” bolt for each side in lower holes. Put



4. Start 3/8-16 nuts on each bolt.

5. Insert one 3/8-16 x 1-3/4 bolt for each side in upper holes. Put



6. Start 3/8-16 nuts on each bolt.

7. Tighten 3/8-16 nuts on each of the 4 bolts connecting the

handlebar extensions to the lower handlebar.



the lower handlebar mount.

9. Now assemble the handlebar to the handlebar extensions.

 

extensions.

10. Insert one 3/8-16 x 1 bolt for each side in lower holes.

11. Start 3/8-16 nuts on each bolt.

12. Insert one 3/8-16 x 1 bolt for each side in upper holes.

13. Start 3/8-16 nuts on each bolt.

14. Tighten 3/8-16 nuts on each of the 4 bolts connecting the

handlebar to the handlebar extension.

NOTE: Handlebar extensions 13285 and 31329 can be used

together on European models.

ATTACH TINE SIDE SHIELDS

1. Locate side shields. (SEE PAGE 26)

2. Take one side shield, raise it up against one side of the tine

guard and hold in place.



these three bolts in each of the three holes of the tine guard,

making sure they also pass through the side shield. Put an



NOTE: The side shield needs to be below the tine hood when

they are attached together.



5. Tighten 1/4-20 nuts on each of the three bolts connecting the

two side shields to the tine guard.

6. Repeat steps 2-4 for the second side shield.

FIGURE 2

handlebar extensions

handlebar

lower handlebar mount

cover plate

transmission

gear case

dipstick

IMPORTANT

NO ENGINE OIL!



INSTALLED IN TRANSMISSION.

FILL ENGINE CRANKCASE

1. Add oil according to engine manual. Do not overll. Use a

clean, high quality detergent oil. Use no special additives with

recommended oils. Do not mix oil with gasoline. Oil level

must be full. Check the oil level by removing oil ll plug. Oil

level should be up to the bottom of the ll plug opening.

2. Always check oil level before starting engine. Refer to engine

manual for capacity and type of oil to use.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Komentarze do niniejszej Instrukcji

Brak uwag

EarthQuake CRT series Instrukcja Operatora Strona 7

Komentarze do niniejszej Instrukcji