EarthQuake CS4518B Instrukcja Operatora Pobierz pdf (Strona 18)

Page 18

8. When ﬁring occurs, push in the choke knob and pull the starter

again to start the engine.

9. Allow the engine to warm up with the throttle lever pulled slightly.

WARNING

Before you start the engine, make sure the saw chain is not

contacting anything.

IMPORTANT

The oil tank should become nearly empty by the time fuel is used up.

Be sure to reﬁll the oil tank every time when refueling the saw.

ADJUSTING CARBURETOR

The carburetor on your unit has been factory adjusted, but may

require ﬁne tuning due to change in operating conditions.

Before adjusting the carburetor, make sure that provided are clean

air/fuel ﬁlters and fresh, properly mixed fuel.

NOTE

Carb is set at factory.

Special tools are required for carb adjustment and can only be

performed by a qualiﬁed service center.

Severe engine damage or personal injury may occur if proper

procedures are not followed.

Operation

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 34 35

Brak uwag

EarthQuake CS4518B Instrukcja Operatora Strona 18